Act now and download your Cisco 200-355 test today! Do not waste time for the worthless Cisco 200-355 tutorials. Download Renew Cisco Implementing Cisco Wireless Network Fundamentals exam with real questions and answers and begin to learn Cisco 200-355 with a classic professional.

2021 Apr 200-355 free practice test

Q61. Wireless clients are experiencing loss of connectivity while roaming between controllers. To fix this, what configuration should be the same on all controllers within the mobility group? 

A. management interface IP address 

B. IP address of the virtual interface 

C. AP Manager interface IP address 

D. IP address of the Service Port 

Answer: B 


Q62. Refer to the exhibit. The wireless engineer has deployed the Cisco 5508 Wireless Controller. The controller is responding on the service port; however, it will not respond on the management interface. Which configuration revision will fix the management interface? 

A. On the switch interface, configure switch(config-if)#switchport trunk allowed vlan add 10. 

B. On the WLC management interface, disable LAG on the management network. 

C. On the switch interface, configure switch(config-if)#switchport trunk allowed vlan 10. 

D. On the WLC management interface, change the VLAN ID to 20. 

E. On the switch interface, configure no spanning-tree portfast trunk. 

F. On WLC Controller > General, disable LAG and reboot. 

Answer: A 


Q63. What are three characteristics of WCS? (Choose three.) 

A. based on a single server licensing system 

B. used for wireless planning 

C. used for real-time tracking of multiple clients 

D. used for wireless management 

E. used for RF fingerprinting 

F. based on a per server licensing system 

Answer: A,B,D 


Q64. Which single tool helps to troubleshoot client-related issues in a WLAN? 

A. The show and debug commands on the controller. 

B. The show commands on the AP. 

C. Client templates on the Cisco WCS. 

D. Client troubleshooting on the Cisco WCS. 

Answer: D 


Q65. Which type of management tasks can be completed on a Cisco WLC remotely from a wireless client? 

A. All management and configuration tasks can be performed from a wireless client except for using debug commands. 

B. In the default configuration, no management or configuration is possible through the GUI or CLI on the Cisco WLC. 

C. The default configuration of the Cisco WLC allows only CLI access and then only the use of show commands, so no configuration is possible. 

D. All management and configuration tasks, except uploads from and downloads to the Cisco WLC, are permitted. 

Answer: B 


Down to date 200-355 exam cram:

Q66. What protocol overcomes the weaknesses of LEAP? 

A. EAP-TLS 

B. PEAP 

C. EAP-FAST 

D. EAP-TTLS 

Answer: C 


Q67. Refer to the exhibit. 

Which two statements about the status of the respective AP on a Cisco WCS version 7.0 map does this icon represent? (Choose two.) 

A. The 802.11a/n radio is administratively disabled. 

B. The 802.11a/n radio has a minor fault. 

C. The 802.11a/n radio has a major fault. 

D. The 802.11b/g/n radio is administratively disabled. 

E. The 802.11b/g/n radio has a minor fault. 

F. The 802.11b/g/n radio has a major fault. 

Answer: B,F 


Q68. What is the maximum number of lightweight APs that can be supported from a single Cisco WCS Navigator management console with Cisco WCS and Cisco WLC running version 7.0 code? 

A. 10,000 

B. 20,000 

C. 25,000 

D. 30,000 

E. 60,000 

Answer: D 


Q69. Which two Cisco WLC management-access methods are available as the default setting? (Choose two.) 

A. SSH 

B. HTTPS 

C. Telnet 

D. HTTP 

Answer: A,B 


Q70. When an AP, in its default configuration mode, connects to a Cisco WLC, which methods are available for remote management access to an AP? 

A. SSL and SSH are available only after configuration by a Cisco WLC version 7.0. 

B. SSH only 

C. HTTPS, and SSH 

D. SSH and Telnet 

E. SSH and Telnet are available only after configuration by a Cisco WLC version 7.0. 

Answer: D