Top Tips Of Rebirth 201 Vce

NEW QUESTION 1
Assume the bigd daemon fails on the active system. Which three are possible results? (Choose three.)

• A. The active system will restart the bigd daemon and continue in active mode.
• B. The active system will restart the tmm daemon and continue in active mode.
• C. The active system will reboot and the standby system will go into active mode.
• D. The active system will failover and the standby system will go into active mode.
• E. The active system will continue in active mode but gather member and node state information from the standby system.

Answer: ACD

NEW QUESTION 2
Which process or system can be monitored by the BIG-IP system and used as a failover trigger in a redundant pair configuration?

• A. bandwidth utilization
• B. duplicate IP address
• C. CPU utilization percentage
• D. VLAN communication ability

Answer: D

NEW QUESTION 3
Refer of the exhibit.

The 816-IP Administrator runs the command shown and observes a device trust issue between BIG-IP devices in a device group. The issue prevents config sync on device bigip3.local.
What is preventing the config sync?

• A. Next Active Load factor is 0 on bigip1.local
• B. Both devices are standby
• C. Next Active Load factor is 1 on bigip1.local
• D. Time Delta to local system is 12

Answer: A

Explanation:
Option A should be bioip3.local?. if choose bigip3.local, you should choose A.

NEW QUESTION 4
A BIG-IP Administrator needs to modify a virtual server that web offload web traffic compression tasks from the target server.
Which two profiles must the BIG-IP Administrator apply to a virtual server to enable compression? (Choose two)

• A. Server SSL profile
• B. Stream profile
• C. Persistence profile
• D. HITP profile
• E. Compression profile

Answer: DE

NEW QUESTION 5
A user wants to use the iHealth Upgrade Advisor to determine any issues with upgrading TMOS from 13.0 to 13.1.
Where can the user generate the QKView to upload to iHealth?

• A. System > Software Management
• B. System > Archives
• C. System > Configuration
• D. System > Support

Answer: D

NEW QUESTION 6
Which Virtual Server type should be used to load balance HTTP traffic to a pool of servers?

• A. Standard
• B. Stateless
• C. Forwarding (IP)
• D. Forwarding (Layer 2)

Answer: A

NEW QUESTION 7
Refer to the exhibit.
Due to a change in application requirements, a BIG-IP Administrator needs to modify the configuration of a Virtual Server to include a Fallback Persistence Profile.
Which persistence profile type should the BIG-IP Administrator use for this purpose?

• A. SSL
• B. Hash
• C. Universal
• D. Source Address Affinity

Answer: D

NEW QUESTION 8
A BIG-IP Administrator is informed that traffic on Interface 1.1 is expected to increase over the maximum bandwidth capacity on the link. There is a single VLAN on the Interface. What should the 8IG-IP Administrator do to increase the total available bandwidth?

• A. Assign two Interfaces to the VLAN
• B. Set the media speed of Interface 1.1 manually
• C. Create a trunk object with two Interfaces
• D. Increase the MTU on the VLAN using Interface 1.1

Answer: C

NEW QUESTION 9
Refer to the exhibit.

How long will the persistence record remain in the table?

• A. 180 seconds after the last packet
• B. 180 seconds after the initial table entry
• C. 300 seconds after the initial table entry
• D. 300 seconds after the last packet

Answer: D

NEW QUESTION 10
A virtual server is listening at 10.10.1.100:80 and has the following iRule associated with it:
when HTTP_REQUEST { if {[HTTP::uri] ends_with "txt" } { pool pool1 } elseif {[HTTP::uri] ends_with "php" } { pool pool2 }
If a user connects to http://10.10.1.100/foo.html, which pool will receive the request?

• A. pool1
• B. pool2
• C. Non
• D. The request will be dropped.
• E. Unknow
• F. The pool cannot be determined from the information provided.

Answer: D

NEW QUESTION 11
A BIG-IP Administrator assigns the default http health monitor to a pool that has three members listening on port 80 When the administrator connects to each pool member via the CURL utility, two of the members respond with a status of 404 Not Found while the third responds with 200 OK. What will the pool show for member availability?

• A. All members offline.
• B. Two members offline and one member online.
• C. Two members online and one member offline.
• D. All members online.

Answer: D

NEW QUESTION 12
Active connections to pool members are unevenly distributed. The load balancing method is Least Connections (member) Priority Group Activation is disabled. What is a potential cause of the event distribution?

• A. Priority Group Activation is disabled
• B. SSL Profile Server is applied
• C. Persistence profile is applied
• D. incorrect load balancing method

Answer: C

NEW QUESTION 13
A BIG-IP Administrator runs the initial configuration wizard and learns that the NTP servers were invalid. In which area of the Configuration Utility should the BIG-IP Administrator update the list of configured NTP servers?

• A. System > Configuration
• B. System > Services
• C. System > Preferences
• D. System > Platform

Answer: A

NEW QUESTION 14
Which Virtual Server type prevents the use of a default pool?

• A. Performance (Layer 4)
• B. Forwarding (IP)
• C. Performance HTTP
• D. Standard

Answer: B

Explanation:
Forwarding (IP) cannot be associated with the pool.

NEW QUESTION 15
A BIG-IP Administrator must configure the BIG-IP device to send system log messages to a remote syslog server In addition, the log messages need to be sent over TCP for guaranteed delivery. What should the BIG-IP Administrator configure?

• A. syslog-ng
• B. Request Logging Profile
• C. HSL Logging
• D. Remote Logging

Answer: D

NEW QUESTION 16
A BIG-IP Administrator is working with a BIG-IP device and discovers that one of the Interfaces on a Trunk is DOWN.
What is the reason for this Interface status?

• A. The switch is NOT connected to the Interface
• B. There is NO transceiver installed on the Interface
• C. There is NO default route configured for this trunk
• D. The media speed of the interface has NOT been set

Answer: A

NEW QUESTION 17
Where is connection mirroring configured?

• A. It an option within a TCP profile.
• B. It is an optional feature of each pool.
• C. It is not configured; it is default behavior.
• D. It is an optional feature of each virtual server.

Answer: D

NEW QUESTION 18
......