Ideas to 400 101 ccie

Q7. Refer to eh exhibit.

You organization has two offices, Site 1 and Site 2, which are connected by a provider backbone, as shown where must you configure an attachment circuit to allow the two sites to connect over a Layer 2 network using L2TPv3?

A. PE Site 1 Se0/0 and PE Site 2 Se0/0

B. PE Site 1 Fe1/0 and PE Site 2 Fe0/0

C. PE Site 1 Fe0/0 and PE Site 2 Se0/0

D. PE Site 1 Fe0/0 and PE Site 2 Fe0/0

Q8. R2#router ospf 1

router-id 10.2.2.2

log-adjacency changes

network 192.168.19.0 0.0.0.255 area 0

R2#show ip ospf

Routing Process "ospf 1" with ID 10.1.1.1

Start time: 00:00:32.552, Time elapsed: 00:03:00.996 Supports only single TOS(TOS0) routes

Supports opaque LSA

Supports Link-local Signaling (LLS) Supports area transit capability

Router is not originating router-LSAs with maximum metric Initial SPF schedule delay 5000 msecs

Refer to the exhibit. After you applied a new configuration to router R2, you executed the show ip ospf

command and noticed that the new router ID was missing. Which two actions can you take to resolve the problem?

A. Reload the router

B. Wait for the hello-interval to elapse

C. Issue the clear ip route command

D. Issue the clear ip ospf command

E. Execute a shutdown followed by a no shutdown on the OSRF interfaces

F. Wait for the dead-interval to elapse

Q9. What can PfR passive monitoring mode measure for UDP flows?

A. loss

B. delay

C. reachability

D. throughput

Q10. Refer the exhibit.

What are two effects of the given configuration? (Choose two)

A. Sources for the 239.1.1.1 multicast stream will register with 172.1.1.1.

B. Multicast stream 244.1.1.1 will operate in sparse mode.

C. Multicast stream 244.1.1.1 will operate in dense mode.

D. It configures 172.1.1.1 as the Bidir u2013 PIM rendezvous point.

E. Sources for the 224.1.1.1 multicast stream will register with 172.1.1.1.

F. It configures 172.1.1.1 as a sparse-mode rendezvous point.

Q11. Which two statements about VPLS are true? (Choose two)

A. Split horizon is used on PE devices to prevent loops

B. PE routers dynamically associate to peers

C. VPLS extends a Layer 2 broadcast domain

D. Spanning tree is extended from CE to CE

E. IP is used to switch Ethernet frames between sites

Q12. Which three elements compose a network entity title? (choose three.)

A. area ID

B. domain ID

C. system ID

D. NSAP selector

E. MAC address

F. IP address

Q13. An IPv6 network has different MTUs on different segments, if the network is experiencing reliability issues,

which option is the most likely reason ?

A. HSRPv6 is configured inly

B. The MTU size is greater than 1470 bytes

C. The do not fragment bit is marked

D. ICMPv6 is filtered

Q14. Which option describes the purpose of the no ip next-hop-self eigrp configuration line in DMVPN

deployment?

A. It allows the spoke routers to change the next hop value when sending EIGRPupdates to the hub router

B. It enables EIGRPto dynamically assign the next hop value based on the EIGRPdatabase

C. It allows the spoke routers to change the next hop value when sending EIGRPupdates to the spoke router

D. It preserves the original next hop value as learned by the spoke routers

E. It preserves the original next hop value as learned by the hub routers

Q15. Which option is a core event publisher for EEM?

A. Policy Director

B. Applet

C. Script

D. Timer

Q16. Refer to the exhibit.

Which option describes the purpose of the as-set argument of the aggregate-address command?

A. It provides a list of AS numbers top which the aggregate is advertised.

B. It provides a predefined AS path in the aggregate advertisement that is used to indicate and aggregate

prefix.

C. It provides as AS path in the aggregate advertisement that contains only the local AS number.

D. It provides an AS path in the aggregate advertisement that includes the AS numbers of the component

members.