It is more faster and easier to pass the Alcatel-Lucent 4A0-100 exam by using Accurate Alcatel-Lucent Alcatel-Lucent Scalable IP Networks questuins and answers. Immediate access to the Renew 4A0-100 Exam and find the same core area 4A0-100 questions with professionally verified answers, then PASS your exam with a high score now.
2021 Aug 4A0-100 exam fees
Q121. SAPs may be a port, a port with a specific VLAN tag in the case of an Ethernet port, or a port with a specific Circuit ID in the case of ATM or Frame Relay.
A. True
B. False
Answer: A
Q122. Which organization eventually became the standards body for IP and related protocols?
A. IEEE
B. IETF
C. NSFNET
D. ITU-T
E. APNIC
Answer: B
Q123. Based on the network diagram (click on exhibit),
Router 1 installs the network D in its routing table, based on a dynamic routing update from Router 2. Which of the following describes the information that will be installed in the routing table?
A. 172.16.9.0/24 next-hop 10.10.10.1
B. 172.16.9.0/24 next-hop 10.10.10.2
C. 172.16.9.0.24 next-hop 10.10.10.3
D. Any of the above
Answer: C
Q124. How does LDP select the path used for an LSP?
A. LDP monitors the available bandwidth on all links and signals the LSP based on this information.
B. LDP uses the shortest hop-count between two endpoints for the LSP.
C. LDP must be configured hop-by-hop by the service provider.
D. LDP follows the path chosen by the IGP.
Answer: D
Q125. From the CE perspective, how does a VPLS operate?
A. A VPLS operates as if 2 sites are directly connected by a single cable.
B. A VPLS operates as if multiple sites are connected through a single switched LAN.
C. A VPLS operates as ifmultiplesites are connected through a single router.
D. A VPLSoperatesas if multiple sites are connected through a series of private point-to-point routed connections.
Answer: B
Latest 4A0-100 exam engine:
Q126. Which of the following is a characteristic of the system address?
A. A physical interface address.
B. A logical address on the router not corresponding to any specific interface.
C. May have any prefix value.
D. A management IP address.
Answer: B
Q127. What is the sequence of events for a client to receive an IP address from the server in the DHCP?
A. Discover, offer, request, acknowledgement.
B. Request, offer, discover, acknowledgement.
C. Discover, request, offer, acknowledgement.
D. Request, acknowledgement, discover, offer.
Answer: A
Q128. Which of the following is an important advantage of protocol layering? (Choose two)
A. Controls distribution of IP addresses.
B. Simplifies protocol functionality.
C. Isolates changes in lower layers from upper layers.
D. Increases protocol operational efficiencies.
E. Layering adds to the fragmentation of the data
Answer: C,D
Q129. Which of the following best describes a repeater?
A. A passive device simply used to connect two or more cables. Does not generate or amplify any signals.
B. A device that receives and retransmits a signal out its ports, but does not do any Layer 2 analysis of the data.
C. A device that receives a signal and based on the Layer 2 destination address, makes a decision on which ports the signal should be retransmitted.
D. A device that receives a signal and based on the Layer 3 destination address, makes a decision on which ports the signal should be retransmitted.
Answer: B
Q130. What is the effective maximum rate of data transmission on a 10 Mbps full-duplex Ethernet link?
A. 5 Mbps.
B. 10 Mbps.
C. 15 Mbps.
D. 20 Mbps.
Answer: D