Q51. - (Topic 8)
Which two methods are supported by the web proxy auto-discovery protocol (WPAD) to automatically learn the URL where a PAC file is located? (Choose two.)
A. DHCP
B. BOOTP
C. DNS
D. IPv6 autoconfiguration
Answer: A,C
Q52. - (Topic 3)
The order of the firewall policies is important. Policies can be re-ordered from either the GUI or the CLI. Which CLI command is used to perform this function?
A. set order
B. edit policy
C. reorder
D. move
Answer: D
Q53. - (Topic 20)
Examine at the output below from the diagnose sys top command: # diagnose sys top 1 Run Time: 11 days, 3 hours and 29 minutes 0U, 0N, 1S, 99I; 971T, 528F, 160KF sshd 123 S 1.9 1.2 ipsengine 61 S < 0.0 5.2 miglogd 45 S 0.0 4.9
pyfcgid 75 S 0.0 4.5
pyfcgid 73 S 0.0 3.9
Which statements are true regarding the output above? (Choose two.)
A. The sshd process is the one consuming most CPU.
B. The sshd process is using 123 pages of memory.
C. The command diagnose sys kill miglogd will restart the miglogd process.
D. All the processes listed are in sleeping state.
Answer: A,D
Q54. - (Topic 6)
Which IPsec configuration mode can be used for implementing GRE-over-IPsec VPNs?.
A. Policy-based only.
B. Route-based only.
C. Either policy-based or route-based VPN.
D. GRE-based only.
Answer: B
Q55. - (Topic 5)
Regarding the use of web-only mode SSL VPN, which statement is correct?
A. It supports SSL version 3 only.
B. It requires a Fortinet-supplied plug-in on the web client.
C. It requires the user to have a web browser that supports 64-bit cipher length.
D. The JAVA run-time environment must be installed on the client.
Answer: C
Q56. - (Topic 11)
Examine the exhibit; then answer the question below.
The Vancouver FortiGate initially had the following information in its routing table: S 172.20.0.0/16 [10/0] via 172.21.1.2, port2
C 172.21.0.0/16 is directly connected, port2 C 172.11.11.0/24 is directly connected, port1 Afterwards, the following static route was added: config router static edit 6 set dst 172.20.1.0 255.255.255.0 set pririoty 0 set device port1 set gateway 172.11.12.1 next end Since this change, the new static route is NOT showing up in the routing table. Given the
information provided, which of the following describes the cause of this problem?
A. The subnet 172.20.1.0/24 is overlapped with the subnet of one static route that is already in the routing table (172.20.0.0/16), so, we need to enable allow-subnet-overlap first.
B. The 'gateway' IP address is NOT in the same subnet as the IP address of port1.
C. The priority is 0, which means that the route will remain inactive.
D. The static route configuration is missing the distance setting.
Answer: B
Q57. - (Topic 9)
Which of the following regular expression patterns make the terms "confidential data" case insensitive?
A. [confidential data]
B. /confidential data/i
C. i/confidential data/
D. "confidential data"
Answer: B
Q58. - (Topic 15)
Which statement is an advantage of using a hub and spoke IPsec VPN configuration
instead of a fully-meshed set of IPsec tunnels?
A. Using a hub and spoke topology provides full redundancy.
B. Using a hub and spoke topology requires fewer tunnels.
C. Using a hub and spoke topology uses stronger encryption protocols.
D. Using a hub and spoke topology requires more routes.
Answer: B
Q59. - (Topic 13)
In transparent mode, forward-domain is an CLI setting associate with ______________.
A. a static route.
B. a firewall policy.
C. an interface.
D. a virtual domain.
Answer: C
Q60. - (Topic 17)
Which statement describes what the CLI command diagnose debug authd fsso list is used for?
A. Monitors communications between the FSSO collector agent and FortiGate unit.
B. Displays which users are currently logged on using FSSO.
C. Displays a listing of all connected FSSO collector agents.
D. Lists all DC Agents installed on all domain controllers.
Answer: B