Up To The Immediate Present BICSI Installer 1 Exam IN101_V7 Exam Question

NEW QUESTION 1
How many cycles are in 10Hz?

• A. 1
• B. 5
• C. 10
• D. 20

Answer: C

NEW QUESTION 2
Which of the following is used to perform continuity and length tests for coaxial cable?

• A. TDR (Time domain reflectometer) with an adapter
• B. OLTS (optical loss test set)
• C. VFL (visual fault locator)
• D. OTDR (optical time domain reflectometer

Answer: A

NEW QUESTION 3
What is the minimum number of consolidation points that should serve an open office furniture cluster?

• A. 1
• B. 2
• C. 3
• D. 4

Answer: A

NEW QUESTION 4
Two truck drivers are communicating over a Citizens Band (CB) radio. Only one driver can send a message at a time with this system.
What type of transmission method is used in this example?

• A. Simplex
• B. Half-duplex
• C. Full duplex

Answer: B

NEW QUESTION 5
Which of the following results from the different optical path lengths in a multimode fiber?

• A. Modal dispersion
• B. Chromatic dispersion
• C. Attenuation

Answer: A

NEW QUESTION 6
Which of the following fire-ratings provides information about smoke leakage?

• A. L rating
• B. I rating
• C. E rating
• D. W rating

Answer: A

NEW QUESTION 7
What is the bend radius requirement for optical fiber cable when the cable is at rest?

• A. 10 times the cables outside diameter
• B. 15 times the cables outside diameter
• C. 20 times the cables outside diameter

Answer: A

NEW QUESTION 8
What is the maximum number of work areas that a CP should serve?

• A. 2
• B. 3
• C. 6
• D. 12

Answer: D

NEW QUESTION 9
What is the minimum inside bend radius for balanced twisted pair (multi-pair) cable?

• A. 25 mm (1")
• B. 50 mm (2")
• C. 6 times the outside cable diameter
• D. 10 times the outside cable diameter

Answer: D

NEW QUESTION 10
What is the size of a rack-mounted unit (RMU)?

• A. 25 mm (1")
• B. 38 mm (1.5")
• C. 45 mm (1.75")
• D. 50 mm (2")

Answer: C

NEW QUESTION 11
You are pre-terminating cable. Where should the labels be placed?

• A. Near end
• B. Far end
• C. Both ends

Answer: C

NEW QUESTION 12
A third 90-degree bend may be permitted in a conduit run if the run does NOT exceed _______ ?

• A. 5 m (16.5')
• B. 10 m (33')
• C. 15 m (50')
• D. 30 m (100')

Answer: B

NEW QUESTION 13
What is the minimum inside bend radius for balanced twisted pair (4 pair) cable?

• A. 25 mm (1")
• B. 50 mm (2")
• C. 4 times the outside cable diameter
• D. 15 times the outside cable diameter

Answer: C

NEW QUESTION 14
A grey backboard should be used to identify ______ backbone cable?

• A. Second-level
• B. Intrabuilding
• C. First-level

Answer: A

NEW QUESTION 15
What is the minimum recommended amount of vertical clearance for open-top cable supports?

• A. 75 mm (3")
• B. 100 mm (4")
• C. 125 mm (5")
• D. 150 mm (6")

Answer: A

NEW QUESTION 16
Which topology uses a linear configuration that places all network devices on one length of cable?

• A. Star
• B. Ring
• C. Bus

Answer: C

NEW QUESTION 17
If the situation requires, a conduit should be terminated ______ the plywood backboard?

• A. Through
• B. Above
• C. Below

Answer: A

NEW QUESTION 18
Which type of optical fiber cable should be color coded with an Orange outer cable sheath?

• A. MM with a 100 um core diameter
• B. Dispersion-shifted SM optical fiber
• C. Polarization maintain SM optical fiber
• D. SM optical fiber

Answer: A

NEW QUESTION 19
Which of the following items may be used as a substitute device for a pulling eye?

• A. Wire mesh grip
• B. Fan-out kit
• C. Innerduct
• D. D rings

Answer: A

NEW QUESTION 20
What is the specified performance level for Category 8 cable?

• A. 100 MHz
• B. 250 MHz
• C. 1000 MHz
• D. 2000 MHz

Answer: D

NEW QUESTION 21
......